2 PEOPLE REQUIREDP004OWNER’S MANUALPDR2W-4836-CWPDR2W-6036-CWPDR2W-6042-CW07.08IT IS MANDATORY TO HAVE A WALL STUD TO SECURELY FASTEN THE RUNNING RAIL
10RUNNING RAIL 44E14B Position the wall bracket for running rail (3) on the running rail (1) as illustrated. Position the return panel glass mount b
115BOTTOM GLASS CLIPS/FIXED PANEL1GLASS HOLDERS5 Fasten the running rail (1) to the xed panel (18) with the glass holders (5). Secure them temporaril
126 FIXED PANELPosition the xed panel (18) on thethreshold of the base (B) as shown. Adjust the wall bracket (3) as well as the return panel
137THRESHOLD6CONTINUED3Remove the xed panel (18) so as to allow placement of the threshold (9) onto the base. Ensure that a bead of silic
14Remove running rail (1) from wall bracket for running rail (3) and return panel glass mount bracket (14). Drill holes in wall with
158CONTINUED16b1819 Apply a bead of silicone at the corner of the nar-row xed panel (18) and the return panel (16c). Proceed to securing the assembl
169 DOOR PANELINTERIOR SHOWER SIDE17 2Install door panel (17), ensuring that a set of rollers (2) are positioned over the running rail (1).Ensure th
17STRAIGHT HANDLE10Install straight handle (8) onto door panel (17). Ensure that clear washers on either side of glass are installed.CONTINUED9
18/FIXED PANELBOTTOM11 DOOR PANEL SIDE GASKET 11 1/2” (12.57 mm)TOP17Install door side gasket (11) onto sliding door panel (17).1711711
19Apply silicone (S) between the bottom of the xed panel (18) and return panel (16b) and the ir appropriate thresholds (9) (10). Silicone application
2PANNEAU FIXE/FIXED PANEL1PARTS LISTING ... 3PARTS TABLE ...
3PARTS LISTING1910234455678121113141516a16b17181916c
4PARTS TABLEITEM PARTS QTY1 Running rail 12 Set of double rollers 2 sets3 Wall bracket for running rail 14 Door stopper 252627 Bottom center guide
5TOOLSHARDWAREPENCILDRILL SILICONESCREWDRIVERSCUTTING PLIER LEVELTAPE MEASURE1/4˝&�1/8˝ DRILL BITS*HACKSAW24 26 27 28ITEM HARDWARE QTY20 Self-dril
6WALL JAMB INSTALLATION11B1C1D1A152315INTERIOR SHOWER SIDE1C1DPut a drop of silicone into each hole drilled on the wall prior to insert an orange wall
72DOOR PANELInstall door side gasket (12) onto sliding door panel (17). Ensure that edge of glass is clean so as to ensure proper adhesion of the gask
83CONTINUED3DMark the glass clips for bottom of xed panel (6) locations on the base, ensuring that the leading edge of the return p
93CONTINUED3HOnce the return panel (16b) has been adjusted, secure the expander (16a) to the wall jamb (15) by way of a clamp so as to keep th
Comments to this Manuals