Alumax 300cv User Manual download pdf (Page 5)

EPH-N00-06095

5-19-04

Page 4 of 7

The Alumax 300cv Continous Hinge Shower

Door is completely reversible and may be installed

hinge-left or hinge-right. Refer to the illustration to

determine the correct position for your installation.

For maximum waterproofing, the hinge jamb should

always be opposite the shower head. These

instructions depict a hinge-left installation.

CAUTION: For safety, the door must always open

outward.

NOTE: The 300cv unit may be installed without

using the sloped curb [A] provided. Its use is definitely

recommended for positive water control on shower sills

with little or no slope.

Measure the wall-to-wall opening at the shower sill and

cut the curb to the exact length. File the ends of curb as

necessary to fit the corner contours of the enclosure.

Place the curb on the shower sill with the raised portion

to the exterior of the enclosure. Make sure the curb is

centered on the sill and lightly mark its position on the sill

with a pencil.

Remove the curb from the sill and run two beads of caulk

inside the penciled marks on the shower sill. Place the

curb in the exact position marked and seat it firmly in the

caulking.

HINGE LEFT

HINGE RIGHT

Cut one wall jamb [C] to the same length as the

strike jamb [G]. Place the wall jamb [C] just cut against

the strike side wall with the bottom end 3/16" from the

raised side of the curb [A]. Plumb the jamb and mark the

hole locations on the wall. Repeat for the other wall jamb.

Remove all parts and drill the walls for mounting hardware.

For tile or marble walls, drill six 3/16" diameter holes

and insert the plastic wall anchors [D].

Attachments to fiberglass or acrylic units can be made

in two ways. If a reinforcement is built into the wall

of unit, drill six 1/8" holes and install mounting screws

directly into the reinforcement. If walls are not

reinforced, drill 3/16" holes and install plastic wall anchors

or toggle bolts (toggle bolts not supplied by (Alumax).

Replace each wall jamb and attach them to the wall with

three #8 x 1 1/2" truss head screws [E].

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Alumax 300cv User Manual Page 5

Comments to this Manuals

Related products and manuals for For Home Alumax 300cv