Alumax 393 User Manual

INSTALLATIONINSTRUCTIONS393 SERIESSTIKSTALLTMSHOWER ENCLOSURECopyright © Alumax Bath Enclosures 1997. All rights reserved.EPH-N00-060115-20-97

EPH-N00-060115-20-97Page 10 of 11192021Peel off the backing on the ALUMAX decal[JJ] and apply to the inside surface of the header.Trim the flap on the

EPH-N00-060115-20-97Page 11 of 1122Cut eight pieces of the larger vinyl [LL] 1/2" longer than the horizontal opening and trim theends on a 45° an

EPH-N00-060115-20-97Page 2 of 11LIMITED WARRANTY AND REMEDYALUMAX BATH ENCLOSURES warrants to its dealers, customers, and all subsequent purchas-ers a

EPH-N00-060115-20-97Page 3 of 11NOTE:This exploded view is typical for aglazed unit with obscure or Decoglass. A glazed door panel with clearglass wi

EPH-N00-060115-20-97Page 4 of 111The ALUMAX 393 STIKSTALL Shower Enclo-sure is completely reversible and may be installedpivot-left or pivot-right. T

EPH-N00-060115-20-97Page 5 of 114Place the two wall jambs [E] into the ends ofthe curb assembly [A]. Masking tape may be usedto hold the curb in plac

EPH-N00-060115-20-97Page 6 of 117Hold the 90° post [K] plumb and carefullymeasure horizontally from the top of each walljamb [E] to the outside edge o

EPH-N00-060115-20-97Page 7 of 1110Snap the fillers [R] into the curb assembly[A] and header assembly [D] between the doorjambs with the raised lip to

EPH-N00-060115-20-97Page 8 of 11131415Thread the two #10-24 x 7/16" square headset screws [X] into the tapped holes in the pivotblocks [Y] (pivot

EPH-N00-060115-20-97Page 9 of 111618Press the four rail end caps [HH] into theends of the top and bottom door rails.17Adjust the drip vinyl [W] by sli